Network Settings
In this section you can setup the Hermes SEG network settings such as Hostname, IP address, Subnet, DNS and gateway. It's highly recommended that the Network Mode be set to Static.
NOTE: This section requires any saved changes to be applied by clicking the Apply Settings button on the bottom of the page.
1. Network Mode
Network Mode can be set to Static or DHCP.
In Static mode, the following fields must be filled in manually (Figure 1):
- Host Name
- Primary Domain name
- IP Address
- Subnet mask
- Gateway
- DNS 1
Figure 1
In DHCP Mode, the following fields must be filled in manually and the rest of the settings will be automatically retrieved from a network DHCP server (Figure 2):
- Host name
- Primary Domain name
Figure 2
2. Host Name
This is the Network name you want to assign to the Hermes SEG without the domain part. For instance, if your host name is smtp.domain.tld, you would simply enter smtp in the Host Name field.
3. Primary Domain Name
This is the Domain name you want to assign to the Hermes SEG without the host part. For instance, if your host name is smtp.domain.tld, you would simply enter domain.tld in the Primary Domain Name field.
3. IP Address
This setting is valid only for Static Network Mode. Enter the IPv4 IP Address that you want to assign to the Hermes SEG.
4. Subnet Mask
This setting is valid only for Static Network Mode. Select the correct Subnet Mask for your network from the drop-down.
5. Gateway
This setting is valid only for Static Network Mode. Enter the IPv4 Gateway IP Address for your network.
6. DNS1
This setting is valid only for Static Network Mode. Enter the IPv4 IP Address of the primary DNS Server for your network.
7. DNS2
This setting is valid only for Static Network Mode. Enter the IPv4 IP Address of the secondary DNS Server for your network if applicable.
8. DNS3
This setting is valid only for Static Network Mode. Enter the IPv4 IP Address of the tertinary DNS Server for your network if applicable.