Flashing IT Firmware to the IBM-ServeRAID-M1015 SAS HBA

Original Article URL: https://opticpow.io/post/cross-flash-ibm-serveraid-m1015-to-it-mode/

The IBM M1015 is the go to Host Bus Adapter (HBA) for enthusiasts wanting a reliable and reasonably priced HBA for systems using advanced filesystems such as ZFS. I acquired a number of these cards for my file-server upgrade. I needed cards to support my new Norco RPC-4224 Chassis. There is a lot of discussion on line about these cards, and re-flashing them to remove the boot & raid firmware. They are easily acquired on eBay for a reasonable cost with a little searching. I have now done this on three cards and not had any issues, however your mileage may vary.

Removing the IBM M1015 firmware

Download Rufus Bootable USB Key Utility

Format a USB key using the Rufus tool, making sure you choose the option to make it bootable with FreeDOS

Download the SAS tools & firmware from SAS2008 and unzip to the USB Key

Boot from the key

Run the following commands to remove the IBM identity to allow it be be flashed with the LSI tools:
```
megarec -writesbr 0 sbrempty.bin
megarec -cleanflash 0
```

Reboot and carry on to the EFI shell below

Using an EFI Shell to Flash your LSI9220-8i

Download a x86-64 (64-bit) shell and place on the USB key. Name the file shellx64.efi

My motherboard, a ASROCK Z77 Extreme 3 has an option to Boot to EFI shell on Removable Device

Using the UEFI Shell

Use the map command to list block devices

To access the USB Key, mount fs0:

Then use the device name to select the device fs0:

Use the DOS style cd and dir to manovure around the USB key

Erasing the existing firmware

There are only a few steps to change your firmware. The ROM is only really required if you want to boot from a drive on this controller. Otherwise it will just slowdown your boot times as the ROM Scans the SAS bus. With a number of cards in your system, it can really add to the boot time.

Erase the existing firmware
```
sas2flash.efi -o -e -6
```

Flash the new firmware

To Flash without the optionROM:

sas2flash.efi -o -f 2118it.bin

With the optionROM:

sas2flash.efi -o -f 2118it.bin -b mptsas2.rom

Grab the SAS address off the card, it’s on the back on a green sticker (ie 500605B0xxxxxxxx)
```
sas2flsh -o -sasadd 500605b0xxxxxxxx
```

Once that is complete, the card is ready to host your disks for your ZFS filesystem.